OZGENC MAKINA OMRM 113, Руководство по эксплуатации

Страница: 29 / 110

OMRM 113 User Manual
33 | P a g e
9.1. Machine Placement
Use predefined hanger lifting points to position the machine at the site described in the plant
layout. You may adopt the aforementioned methods of transport. Using any other method may
damage your machine.
9.2 Fixing on Ground
The machine must be placed considering the maintenance and operating spaces. Rear and side
spaces and spaces recommended for maintenance procedures are above-mentioned. To fix the
machine on the ground properly, make sure that the vibration-blocker stands which are provided
with the machine are mounted.
9.3 Start-up Preparation
Moving parts of the machine are generally cleaned by an anti-rust oil. Power connection and
pneumatic connection are made for the machine to function properly.
Electrical connections of the machine must be conducted by an expert staff.
9.4 Electrical Connections
VOLT 400 V
HERTZ 50 Hz
CURRENT 6.5 A
POLE 3P+N+E
Important Note!
Drivers work in the range of 200-230 V. Driver may be burnt if overvoltage is applied. Check the voltage in
the space where the machine will be used before supplying electricity to the machine. Also, grounding
must be max. 2V. Otherwise, measurement faults may be encountered in the machine.