STEP 1: Verify Package Contents
Verify package contents by emptying contents of bag(s) and confirming all parts are included and undamaged.
Tip: Do this at home before you leave on your trip.
STEP 2: Set Up the Tent
A)
Select a smooth level site and spread out your tent.
B)
Extend all of your poles and sort into groups by style i.e.roof center poles, roof side poles, leg poles, eave poles,
etc. This will simplify the assembly process. ( see fig. 1)
C)
Lay out the Center Roof Pole and Side Roof Poles as shown below (see fig.2).
(a) Take Center Roof Pole (CRPL-395BK),slide through the hub (TPM-120-2) by matching the white hub to
the white locking into place (in the middle of CRPL-395BK). And then slide into the corresponding hubs by
matching the red hub to the red locking into place.
(b) Take Side Roof Pole (RRPL-395BK/LRPL-395BK),slide through the hub (TPM-060-2) by matching the
white hub to the white locking into place (in the middle of RRPL-395BK/LRPL-395BK). And then slide into the
corresponding hubs by matching the red hub to the red locking into place.
green sticker
blue
purple
yellow
blue
red
red
red
red
white
white
white
Center roof pole x 1 line
CRPL-395BK
Right roof pole x 1 line
RRPL-395BK
Left roof pole x 1 line
LRPL-395BK
Roof gable pole x 6 lines
RGPL-171BK
Side corner leg pole x 4 lines
LPSA-171BK
Center leg pole x 2 lines
LPCA-171BK
Eave pole x 6 lines
EPOL-30BK
fig. 1
fig. 2
THIS RECREATIONAL PRODUCT REQUIRES TWO ADULTS TO ASSEMBLE
ASSEMBLY INSTRUCTIONS
*
Unless otherwise specified all instructions will be given assuming the assembler is facing the front opening of the tent.
*
Carefully fold out your poles, using caution to prevent snapping the shock-cording. Make sure each pole segment is “seated” into
the next
section before flexing the pole during set-up. Sort POLES by type and length; refer to parts list descriptions.
* Do not drop tent pole bag.Do not bounce tent bag on its end to remove tent, as these actions may damage the shock-cording and/
or pole ends.
CRPL-395BK
LRPL-395BK
STEP 4: Add Accessories
A) Hanging Shelf Unit:
Fasten
S-Hooks found at top of hanging shelf
to corresponding number of loops
located on tent’s inside corner.
B)
Install Divider Curtain by
matching its toggles to fabric loops
on inside walls.
A)
Stake tent by driving stake through
the pin-rings on base of tent.
B)
To secure guy lines, find the guy line
plastic slider and look for the portion of
the line opposite the knot. Pull this
portion, forming a loop (works like a slip
knot). Extend guy line to ground and
stake. Repeat with remaining guy lines.
G)
Attach Eave Poles to the rainfly by placing the pole
ends in the pole pockets on underside of rainfly to
secure the poles.
H)
Take the purple center Leg Poles (LPCA-171BK)
and insert into the purple opening on hubs then insert
ends onto pin-rings at tent base. Take the green side
corner leg poles(LPSA-171BK) and insert into the green
opening on hubs then insert ends onto pin-rings at tent
base. Tie the fabric ties around each leg pole to
secure.
F)
Take the Eave Pole (EPOL-30BK) and insert end
into yellow taped opening on all six hubs. Drape
Rainfly over tent.
I)
Connect each S-Hook on the rainfly to
the D-rings near top of corner leg poles.
C
A
B
Tip: Stakes provided are for solid
ground. Camping in sand? We suggest
corkscrew style. Check favorite retailer for
availability.
D)
Slide Roof Gable Pole (RGPL-171BK) into the
corresponding hubs by matching the blue hub to the
blue locking into place. Repeat with all other Roof
Gable Poles.
STEP 3: Stake the Tent
E)
Position the tent body underneath the roof assem-
bly. Hook S-hooks on tent body roof to the holes in
each corresponding hub. Also connect quick clips to
the poles.
G
F
1
F
2
If your product does not work properly because of a defect in materials or workmanship, Westfield Outdoor Inc will, for 6 months from the date of purchase, at its option
either (a) repair our product with new of refurbished parts, or (b) replace it with a new product. The decision to repair or replace will be made by Westfield Outdoor Inc
WESTFIELD OUTDOOR INC RESERVES THE RIGHT TO MAKE SUBSTITUTIONS TO WARRANTY CLAIMS IF PARTS ARE UNAVAILABLE OR OBSOLETE.
If repair is needed during the limited warranty period, the purchaser will be required to furnish a sales receipt as proof of purchase indicating date of purchase; amount
paid, and place of purchase. Product will not be covered under warranty due to damages resulting from misuse, excessive or abusive usage, and/or inclement weather
conditions(i.e. wind storms,hurricanes,lightning storms,tornadoes).Acts of nature resulting in damage to tent and its components are not covered under this limited
warranty. In such event, the consumer assumes cost of needed parts. Westfield Outdoor Inc is not responsible for normal wear and tear, zipper exhaustion, or the natural
breakdown in materials that occurs with extended use.
UNDER NO CIRCUMSTANCES SHALL WESTFIELD OUTDOOR IN BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES. Some states do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you.
Westfield Outdoor Inc EXPRESSLY EXCLUDES ALL WARRANTIES, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE. Some states do not allow the exclusion or limitation of implied warranties, so the above exclusion may not apply to you.
NOTWITHSTANDING ANYTHING TO THE CONTRARY, WESTFIELD OUTDOOR’S AGGREGATE LIABILITY, WHETHER IN CONTRACT OR TORT, SHALL BE LIMITED
TO ACTUAL DIRECT MONEY DAMAGES IN AN AMOUNT NOT TO EXCEED THE PRICE PAID BY THE END-USER FOR THIS PRODUCT.
HOW TO OBTAIN WARRANTY SERVICE: Call the toll free number during the business hours mentioned below. You must have a copy of your purchase receipt from an
authorized dealer as proof of purchase at time of call. Under no circumstances is Westfield Outdoor Inc obligated, nor will it warranty, any Westfield Outdoor Inc product
that is sold or provided by an unauthorized, secondary market dealer. This shall include, but not be limited to, surplus dealers, public markets, etc.
HOW TO ORDER REPLACEMENT PARTS: When ordering replacement parts always include the Model Number, Part Number, and Part Description.
Call toll free 1-877-579-1550
Mon-Fri, 8:30 a.m. to 5:30 p.m. (Eastern Standard Time)
* Make sure all doors are zipped nearly closed, leaving space to allow air to escape when repacking.
* Store all poles and stakes in their corresponding bags to prevent possible tearing or damage to fabric.
DISASSEMBLY INSTRUCTIONS
STEP 1: Remove Rainfly
A)
Detach S-Hooks and nylon fasteners that
hold down rainfly.
B)
Take eave poles out from the pole pocket.
C)
Fold the rainfly for storage.
STEP 2: Take Down the Accessories
A)
Remove the Divider Curtain by detaching
toggles from fabric loops. Fold for storage.
B)
Detach Shelf and the detachable floor by
unhooking S-hooks from loops. Fold floor for
storage. Place shelf in carry bag.
STEP 5: Fold the Tent
Fold tent into rectangular shape the width of pole
bag. Place RFLY, FLOR, DVDR and gear loft on tent
body. Lay pole bag at one end of tent and roll tightly
together, slowly squeezing air out as you go.
STEP 3: Remove the Stakes
Carefully remove stakes by pulling out the hook
ends.
Tip: Do not pull or tug at the stake
loops sewn onto the fabric body.
Remove
excess soil from the stakes and store them in
their bag.
STEP 4: Take Down the Tent
A)
Remove the leg poles from the pin-rings and
undo ties securing leg poles.
B)
Unfasten the S-hooks from hubs to remove tent
fabric.
C)
Disengage poles from hubs.
D)
Carefully fold poles and store them in their bag.
TIP: Following these instructions will
make it easier to fit tent into bag.
LIMITED 6 MONTHS WARRANTY
PL.MOLD
1EA
(TPM-120-2)
PL.MOLD
(TPM-120-2)
1EA
PL.MOLD
2EA
(TPM-071-2)
PL.MOLD
(TPM-071-2)
2EA
PL.MOLD
(TPM-070-2)
2EA
PL.MOLD
2EA
(TPM-060-2)
PL.MOLD
(TPM-060-2)
2EA
PL.MOLD
2EA
(TPM-070-2)
PL.MOLD
2EA
(TPM-120-1)
PL.MOLD
(TPM-120-1)
1EA
PL.MOLD
(TPM-120-1)
1EA
CRPL-395BK
RRPL-395BK
LRPL-395BK
RGPL-171BK
EPOL-30BK
LPSA-171BK
LPCA-171BK
TPM-060-2
TPM-120-2
TPM-070-2
TPM-071-2
TPM-120-1
TPM-120-1
white sticker
white sticker
white sticker
white sticker
white sticker
RRPL-395BK
PL.MOLD
(TPM-071-2)
2EA
PL.MOLD
(TPM-070-2)
2EA
PL.MOLD
(TPM-060-2)
2EA
TPM-060-2
TPM-071-2
TPM-070-2
white sticker
white sticker
white sticker
white sticker
red
red
white
white
Содержание WF-1414V
Страница 1: ......
