ASSEMBLY INSTRUCTIONS
MODEL W418.1S
SUN SHELTER
8’ X 6’
NOTE:
To take down the canopy, follow steps above in the reverse
order. Place stakes into stake bag and poles into pole bag, which
are provided. The Canopy should be folded into equal parts toward
the center to distribute the bulk. Start a small tight roll, the width of
your carry bag. Once rolled, tie a string or rope around canopy to
hold it in place. Place canopy and stake bag into carry bag.
MAKE SURE IT IS CLEAN AND DRY BEFORE STORING.
Canopy should appear as shown.
STEP 7:
Stake down canopy by inserting stakes through the webbing
loop at each corner of the canopy. Hammer stakes into ground at a
45° angle, by using a hammer or mallet.
Make sure to use strap to pull canopy
out even and tight. Sandbags are
provided for use at the beach. Fill
the bags with sand to hold the canopy
in place.
STEP 6:
Where the poles cross there
are fabric ties, tie them around both
poles to hold them together.
STEP 5:
Clip the plastic hooks attached
to the canopy walls to the poles.
STEP 4:
Starting at the back corners of the shelter,
place ends of the fiberglass frame pole that runs
across the front of the canopy roof into the fast feet
located at the back of the canopy, by gently flexing
the pole upward into an arch. Repeat the same
procedure at the front corners of the canopy with
the pole that runs across the back of the canopy roof.
STEP 3:
Slide each fiberglass pole (A) through the sleeves on the
top of the canopy roof. Position poles so that equal pole lengths
extend on either side of pole sleeves.
STEP 2:
Extend the fiberglass frame poles by pulling out each
section and placing it into the metal connectors. You will have
two fiberglass poles (A).
STEP 1:
Spread canopy out flat with the pole sleeves up.
IMPORTANT:
WE ADVISE YOU TO ASSEMBLE THE SHADE
CANOPY ONCE BEFORE USE TO BECOME FAMILIAR WITH
THE ASSEMBLY
NOTE:
PLEASE LOOK AT THE REPLACEMENT PARTS DIAGRAM
TO SEE HOW YOUR FRAME IS ASSEMBLED.
