21
KK-1302-0001 R(11)
29.03.2022
TRN2101 C
ontrol Board /
3 and 4 Arm Turnstile Rotor Arms Centre Position Settings
System reset and service/ adjustment mode
2
1
Prog Reset
TRN2101 Control PCB
‘
Prog
’
and
‘
Reset
’
buttons.
Press and release reset button. Press and hold
‘p
rog
’
Button while system
reset buzzer warning is on. Release
‘
prog
’
Button when rapid beep is heard.
This activates manual command service mode. (See fig.3)
Single Button Setting Mode
SERVİS MODU
Arm Position Setting
3
4
Manually bring any one of the rotor arms in centre position; press
and release PROG button quickly. Warning tone indicates that the
arm centre position is saved.
Press PROG button again and
release when very rapid
warning tone is heard.
geldiğinde bırakınız.
Setting Other Arm Positions
Saving Settings
SONLANDIRMA
5
6
Turn rotor to position other arm at the centre. Press and release
‘prog
’
button quickly and hear the ‘saved’ confirmation tone.
Repeat same procedure for other arms. Note: Three beeps
indicate that the arm has already been adjusted. In this case
move on to the next arm.
Press and hold
‘
prog
’
button. Release
button when rapid beeping tone is
heard. Final long beep confirms that
settings have been saved
Exiting Service Mode
7
Press and release
‘
RESET
’
button
to exit service mode.Turnsile
returns to normal operating mode.
+
+
+
2
5.4.3 Magnetic Encoder Arm Stop Settings
