should be connected to the tweeter. Make sure that the polarities on all three
connections are correct.
After all connections have been made, tweeter attenuation can be adjusted
through the switch mounted on the crossover. The level of tweeter attenua-
tion can be adjusted from -3dB to a reference level of 0dB. These adjustments
should be tested with reference listening material to insure the correct level has
been selected. If you fi nd that your installation is producing a “confused” center,
double check that the polarities of all the connections are correct. If the prob-
lem persists it may be necessary to reverse the polarity (phase) of one channel
in the component system (left or right) through the phase switch located on the
crossovers. Again test the system with reference listening material to verify the
phase selection.
Once these steps have been taken the tuning and installation of your new Oz
audio system is completed.
If you have any diffi culties or questions please contact your local authorized
dealer or call Oz Audio Technical Support Line at 561-998-0211.
assembly and proceed to cut the opening. Once this step is completed you
can place the tweeter assembly into place. Place the retaining clips through
the slotted openings located inside of the housing adjacent to the brass insert.
When aligned correctly the two clips should leave an opening for the supplied
set screw.
At this point in the installation you can thread the supplied set screw into the
brass insert and continue to tighten the fastener completely. It is highly recom-
mended that you tighten this screw by hand and not with a power drill to prevent
potentially damaging the retaining clips or the fl ush cup assembly. Feel free to
insert the tweeter into the fl ush mount assembly taking care to run both wires
through one of the remaining openings along the inside edge of the fl ush cup
assembly and aim accordingly.
Crossover Installation:
The crossovers should be mounted in a dry, moisture free location. Never install
the crossover in the door where it can be damaged by water and moisture.
There are three sets of connections on the crossover. The input terminals
should be connected to the source of the signal (radio or amplifi er). The woofer
terminals should be connected to the mid-bass driver. The tweeter terminals
Содержание ME OZ 180CS
Страница 1: ......
