05/06
Do not leave your child unattended in the seat at any
time.
Any luggage or other objects liable to cause injuries in
the event of a collision shall be properly secured.
The Enhanced Child Restraint System shall not be used
without the cover.
The seat cover should not be replaced with any other
than the one recommended by the manufacturer,
because the cover constitutes an integral part of the
restraint performance.
Ensure that all components of the children's safety seat
are secured to the correct position during the daily use
of the vehicle, that they are not liable,during the
everyday use of the vehicle,to become trapped by a
moveable seat or in a door of the vehicle.
Please keep operation instruction for its life period .
Do not use this child seat at home.It has not been
designed for home use and should only be used in your
car.
For the reason of safety,the child seat must be fixed
inside the vehicle using ISOFIX anchorages even if you
do not put your child inside the child seat.
Never use a second-hand product,as you can never be
certain what was happened to it.
Instructions
Safety Guidelines
1
2
USAGE
4
USAGE
4
4.4 Adjust and use the
Y-shaped belts
Loosen the Y-shaped belts
The Y-shaped belts can be slackened
by pressing the adjuster(under the
seat cover). Press the adjuster as
you grip the two Y-shaped belts with
your another hand.Pull the Y-shaped
belt towards you to loosen the
Y-shaped belts.
To t
ighten the Y-shaped
harness
belts
Pull the front upwards until the
Y-shaped belt is fully tightened.
The Y-
shaped belt should be adjusted tightly
without causing discomfort to
the
child.
A loose Y-shaped
harness
belt can be
dangerous
.
Check the
harness
belt adjuster and
tighten it each time when the child is
placed in the seat.
Position2
Position1
Position3
Position4
4.5 Adjust the handle
Press the button to adjust the length of support leg and make sure the bottom
of the support leg touch the ground completely,to suitable for different height of
car seat. When the bottom of the support leg touch the ground completely, the
support leg status window shows green.
4.6 Adjust the length of support leg
4.7 Adjust the ISOFIX
attachment bars
Support leg
adjusting button
Status window
shows green
ISOFIX adjusting button
Maximum position
Minimum position
The handle can be adjusted in 4 positions. At the same time,
squeeze-in
the handle
adjusting buttons
at both ends of the
handle, rotate the handle to the desired
position
, and release
the handle adjusting button
s
.
Position the handle forwards,
backwards or upright,
make sure the handle is locked
in
position
by
releasing
the handle adjusting button
, you should
hear a 'click'
.
Notice:
W
hen the vehicle
is in use
,the handle must be in the
position
4.
This is an i-Size Enhanced Child Restraint System. It is
approved according to Regulation No.129, for use in, i-Size
When used as an infant carrier module without ISOFIX base
,this type of child safety seat is suitable for the car equipped
with the 3-point belts and approved by ECE R16.
