Page 4
Manual Version: v1.0
Model Code: 3226
Oypla.com LLP / www.oypla.com
Contents
1
Front Cover
-
2
Safety
Instructions
-
2
Warning
Instructions
-
3
Operating
Instructions
-
5
Cleaning and
Maintenance
-
6
Problem-Cause-
Solution
-
6
Back Cover
If the level of water sinks too far, any sludge in the shaft will dry out
quickly to stop the pump from starting up. It is necessary, therefore,
to check the submersible motor pump regularly (by carrying out start
up tests).
The floater is adjusted in a way that the pump can immediately be
started.
NOTE: The pump shaft should have minimum dimensions of
40x40x50cm, so that the floating switch can move freely.
MAINS SUPPLY
Your new submersible pump is equipped with a shockproof plug
according to regulations. The pump is designed to be connected to a
230V~, 50Hz safety socket.
Make sure that the socket is sufficiently secured (min.6Amp.) and is
in excellent condition. Introduce the plug into the socket and the
pump is ready to go.
IMPORTANT NOTE: If the mains cable or plug suffers any damage
from external action, repairs to the cable are prohibited.
NOTE: This work may only be performed by a qualified electrician or
customer service.
AREAS OF USE
This pump is used primarily as cellar pump. When installed in a shaft,
this pump provides protection from flooding.
They are also used wherever water has to be moved from one place
to another, e.g. in the home, agriculture, horticulture, plumbing and
many other applications.
SETTING TO WORK
After having read these instructions carefully, you can set your pump
to work, reconsidering the following item:
• Check if the pump rests on the ground of the shaft.
• Check if pressure cord has been attached properly.
• Check if electrical connection is 230V~, 50Hz.
• Check if socket is in good condition.
• Make sure that the water and humidity can never come to the
mains supply.
• Avoid pump running dry.
