Page 6
Manual Version:
V1.0
Model Code:
4716, 4717, 4718, 4719, 4720, 4721, 4722, 4723, 4724, 4725, 4726, 4727
Oypla.com LLP
/ www.oypla.com
Contents
1
Front Cover
2
Safety
Instructions
3
Assembly
Instructions
7
Operating
Instructions
7
Back Cover
Shortening the Blind
Note: Before fitting, you can custom-fit the blind to the correct height. *Use
figures 11 to 14 to help you through this process.
1)
Height
–
when the blind is fully lowered, there should be no slats
overlapping at the bottom of the blind. If overlapping occurs, you can
remove slats to allow a custom fit.
2)
Hold the blind at the desired location and allow it to fully lower. In the
open position, the slats should be approximately 2cm apart.
3)
Lay the blind on a flat surface and remove the caps on the bottom end
slat. The caps are attached to the lift cords.
4)
Cut lift cord 2cm above the cap and remove. Pull the lift cord from these
slats to allow them to slide out of the ladder rung.
5)
Count the number of slats you wish to remove. Pull the lift cord from
these slats to allow them to slide out of the ladder rung.
6)
Remember to allow for the bottom end slat to be reinserted. Reinsert the
lift cord through the cap holes and then insert back through the top and
the caps.
