Operating Instructions
Your submersible pump is designated for the circulation of water with maximum temperature of
35°C.
This pump may not be used for other fluids, especially motor fuels, cleaning fluids, and other
chemical products!
1. Installation
The submersible motor pump is installed as follows:
In a stationary position with fixed pipeline.
In a stationary position with a flexible hose pipe.
PLEASE NOTE: You should never install the pump by suspending it unsupported from its delivery pipe or
power cable. The submersible motor pump must be suspended from the specially provided handle or
be placed on the bottom of the shaft. To guarantee that the pump works properly, the bottom of the
shaft must be kept free of sludge and dirt of all kinds.
If the level of water sinks too far, any sludge in the shaft will dry out quickly to stop the pump from
starting up. It is necessary, therefore, to check the submersible motor pump regularly (by carrying out
start up tests).
The floater is adjusted in a way that the pump can immediately be started.
NOTE: The pump shaft should have minimum dimensions of 40x40x50cm, so that the floating switch
can move freely.
USER MANUAL Model No: 3226
