Oxford Instruments Mercury iTC, Руководство пользователя

Страница: 55 / 146

Handbook
November 2011 / 59-UMC0071 / Issue 01
Mercury iTC
Page 55
USER INTERFACE
Original Instructions
3.2.14 Heater configuration page
Figure 3-28 Heater configuration page
This page displays a set of values for each heater that is configured. The following fields
and values are displayed for each heater:

Heater #
Displays the number of the heater. This number cannot be edited.

Name
A name to identify the heater. Tap this field once to display an alpha-numeric keypad
and enter a new name.

Lim (V)
The maximum voltage to be applied to the heater. Tap this field once to display a
numeric keypad and enter a new value.

Res (
Ω
)
The electrical resistance of the heater in ohms. Tap this field once to display a
numeric keypad and enter a new value.

P(W)
This field displays the power that is currently being applied to the heater, both in
watts and as a percentage of the maximum. This value cannot be edited.
The page also contains the following buttons:

Control
Tap once to display the Control Loop Configuration page (see Section 3.2.9 ).

Calibrate
Tap once to calibrate this measurement circuit. This routine takes approximately one
minute. An error message is generated if the calibration fails for any reason.