97-00017-001 REV.A
Panel Mounting Instructions
The Monitor is mounted thru a cut-out (see below), and locked with aluminum locking bars that slide into grooves in the sides of the case. A .050” hex-wrench is used on the locking bar setscrews.
Страница 1: ...AC or 240VAC 50 60 Hz Adjusting the Temperature Setpoints Setpoint settings on the M320 can be read and adjusted by pressing and holding either the High or Low momentary switch on the front panel The...
Страница 2: ...change from the Normally Closed state to the Normally Open state and remain open until the temperature rises above the high setpoint When the diode temperature reaches the low temperature setpoint th...
Страница 3: ...Panel Mounting Instructions The Monitor is mounted thru a cut out see below and locked with aluminum locking bars that slide into grooves in the sides of the case A 050 hex wrench is used on the lock...
