Ver. 06.30.20
INSTRUCTIONS
STEP 1
First prepare the seat assembly. Insert the steel rod
through the predrilled holes of the seat back and seat .
Place the nylon washer on the rod followed by the
polyethylene blocks as shown.
STEP 2
On a clean flat surface, lay right leg assembly on its side
mortise holes facing up. Place front seat rail , and rear
seat rail into mortise of right leg assembly. A steel pin
indicates the rear of the chair. Next, slide the 2mm washer
onto the steel pin at the rear of the chair.
Ver. 2019.8.10
3
A
STEP 3
Line up the completed seat assembly so the polyethylene
block fits into the long mortise in the rail on the right leg
assembly and the steel pin of the leg assembly fits into the
mortise located on the seat back.
STEP 4
Place left leg assembly onto those parts already assem-
bled. Again, slide the 2mm washer onto the steel pin, align
the polyethylene block and the steel pin to fit into the
mortise of the rail on the left leg assembly and the seat
back.
STEP 5
With a hammer, drive 8 total dowels into the predrilled holes found on the front and rear of the leg assemblies. Insert the
tapered end of the dowels first. NOTE: The dowels should be easily driven in flush. If there is strong resistance, do not force the
dowel. Sand to smooth off areas around the dowel pins. Your chair is now ready to enjoy!
5
E
4
D
A
C
B
2
1
1
2
B
C
6
E
3
5
6
4
