Owon SDS1000, Руководство пользователя

Страница: 20 / 68

3.Quick Start
15
Turn the Horizontal Position knob to change the horizontal position of
channel and push the Horizontal Position knob to set the
triggering
displacement
back to 0 as a shortcut key.
3. Push the Horizontal HOR button to switch between the normal mode and
the wave zoom mode.
Introduction to the Trigger System
As shown in Figure 3-12 , there are one knob and three buttons make up
Trigger Controls . The following practices will direct you to be familiar with the
setting of the trigger system gradually.
Figure 3-12 Trigger Control Zone
1. Push the Trigger Menu button and call out the trigger menu. With the
operations of the menu selection buttons, the trigger setting can be
changed.
2. Use the Trigger Level knob to change the trigger level setting.
By turning the Trigger Level knob, the trigger indicator in the screen will
move up and down. With the movement of the trigger indicator, it can be
observed that the trigger level value displayed in the screen changes
accordingly.
Note : Turning the Trigger Level knob can change trigger level value and
it is also the hotkey to set trigger level as the vertical mid point values of
the amplitude of the trigger signal.
3. Push the Force button to force a trigger signal, which is mainly applied to
the "Normal" and "Single" trigger modes.