O
W
L
M
D
M
-
1
F
o
x
OWLplane.com
Page : 7
Hardware Needed
For Fuselage and Canopy:
▷
M3 x 0.5mm thread x 12mm screws with their washers for outrunner motor to motor mount wall - 4x.
▷
Self tapping screw M3x20mm or M2.5x20mm with their washers for mounting motor wall to the fuselage
(Fuselage - N0) - 6x.
▷
4mm OD and 56mm steel long shaft for main wheel axles - 2x.
▷
Landing gear wheel stop set collar 9x4.1mm for main wheel axles - 4x.
▷
2.0mm OD and 36mm steel long shaft for tail wheel axle - 1x.
▷
Landing gear wheel stop set collar 9x2.1mm for tail wheel axles - 1x.
▷
Ballpoint pen springs for Canopy - 1x.
For Wings (excluded control surface):
▷
3D printed wing and fuselage pin left and right - 2x.
▷
1mm OD aluminum wire with about 40mm length - 2x.
For Elevon, Stabilizer and Elevon Servos:
▷
1.5mm - 2mm rod for creating flap, aileron, elevator and rudder hinges (ER308L - TIG Stainless Steel Rod).
▷
1.5mm - 2mm rod for flap, aileron, elevator and rudder pushrod (ER308L - TIG Stainless Steel Rod).
▷
Landing gear wheel stop set collar 9x2.1mm for flap, aileron, rudder and elevator - 6x.
▷
Linkage stopper D2.1mm for for flap, aileron, rudder and elevator - 6x.
▷
2.0-2.5mm OD shaft for creating pins connecting two parts for aileron, flap and stabilizer.
