© 2 Save Energy Limited 2013
15
Additional Installation Information
Room Sensor Factory Reset (Delete Network OWL Pairing)
You can factory reset the Room Sensor by pressing both the Standby and Away buttons
together for a minimum of 10 seconds. The 3 LEDs will start flashing indicating that it is in
pairing mode. Refer to Getting Started with OWL Intuition Network Gateway guide if you
need to factory reset the Network OWL.
Room Sensor - Relay Unit Pairing Mode
You can place the Room Sensor into Relay Unit pairing mode by pressing all 3 buttons
together for a minimum of 4 seconds. The 3 LEDs will start flashing indicating that it is in
pairing mode. If the Room Sensor is already paired to a Relay Unit pressing the 3 buttons
will delete that pairing. Refer to Relay Unit Installation Instructions for further information.
Safety Switch
The Room Sensor is fitted with a safety switch that is automatically activated when the
front of the Room Sensor is removed from the backplate. Safety switch activation will im-
mediately turn the heating off and the web dashboard will show an appropriate warning
message. The Room Sensor MUST be installed onto the special backplate supplied other-
wise the safety switch will not operate and the Room Sensor will not work.
