Filename:MEDIA CENTER MANUAL
12/11/06
Page 4 of 6
Installation Instructions
MEDIA CENTER
Model MCRC303
MCRC303 carton includes the following items:
1.
One (1) each MCRC303
2.
One (1) each UL Listed Power Supply
Introduction:
Congratulations on purchasing the Media Center by OWI.
The OWI MEDIA CENTER is a 50-Watt (25 x 2) High Fidelity Amplifier, Mixer, and
Room- Combiner all in a small package that fits into a double gang box. This high quality
durable unit is capable of powering up to 4 speakers per side for voice, music and paging. The
Media Center has 3 independent inputs that can be used for Line or Mic input.
The MEDIA CENTER is meant to replace bulky racks, amps, and mixers. OWI made to
fit into a double gang box where space is limited.
Assembly Steps:
Please note that the GANGBOX SHOULD BE cut into the wall and all wires are best to be run
in the wall.
Mark the wall were you will be cutting and make sure that nothing is behind the wall before you
cut. Be sure that nothing is going to disturb the placement of the INWALL AMPLIFIER.
Please note that this is a digital amplifier. This amplifier is small enough for it to fit into a double
gang box, and gives off very little heat.
Important!
All connections should be made with the power turned
OFF!
Note:
Strip all wires 3/16” and place the wires in the connector and tighten screw to the right.
Note: this must be done for each input.
1)
Disconnect the Green Phoenix connector and connect the wires for your line source/s to the Green
Phoenix connector. Then Plug this into the MEDIA CENTER to the desired input (1, 2, or 3) be sure that
the RED jumper is in the Line spot.
2)
Disconnect the Green Phoenix connector and connect all the microphone/s to the MEDIA CENTER to the
desired input (1, 2, or 3) be sure that the RED jumper is in the Mic spot.
3)
Disconnect the Green Phoenix connector and connect the speaker wires to the SPKR CH1 (Red to +,
Black to -) phoenix connectors SPKR CH 2(Red to +, Black to -) phoenix connectors. These are both 25
watts each.
4)
Connect the UL listed 15-Volt transformer (supplied) to input the amplifier. The wires must not be crossed
