OWI AMP4IC6, Руководство по установке, Страница: 4 / 14

Filename:AMP4IC6 MANUAL
12/12/06
Page 4 of 14
Installation Instructions
Model AMP4IC6
(UL Listed)
AMP4IC6 carton includes the following items:
1. One (1) each AMP4IC6
2. One (1) each UL Listed Power Supply
Introduction:
The AMP4IC6 is designed to provide a 6.5 inch speaker that is self powered allowing line input audio that is
either balanced or unbalanced to provide the input signal. The power amplifier provides up to 25 watts of
power. It has enough power to allow up to four total speakers to be powered by one powered speaker. The
additional three can be non-powered. This would then allow each speaker to have approximately 5 watts of
power. Five watts would be enough power for background music, voice paging or many voice applications.
Specifications:
Model AMP4IC6
Frequency Response 50 Hz to 15kHz. HF is optimized to enhance frequency response of the
speaker.
THD <.1%
S/N >90dB
Input Configuration Differential (noise reducing)
Minimum Common Mode Rejection 40dB
Maximum Power Output 25watts
At load impedance 4 Ohms (2 speakers in parallel or 4 speakers in series parallel)
Minimum Power Supply Voltage 8 Volts
Maximum Supply Voltage 14 Volts
Maximum current protected Yes
Short Circuit protected Yes
One wire to ground protected Yes
Minimum Load Impedance 3.2 Ohm
Input Load Impedance 10K Ohm
Maximum number of Amplifiers on
one line
4
Power Supply 12 Volts AC 12- 14V AC
Inputs 4 Balanced Line
Outputs 1 Balanced Line
Controls 4 Input level Controls
1 Line out Level Control
1 Amplifier Gain Control
Outputs 4 Output Jacks allowing automatic correct
wiring for series parallel connection by simply plugging each speaker
into its jack.
Heat sink An oversize heat-sink is provided
High Voltage The highest voltage on the PCB is 12 volts
Protection The amplifier is protected against short and
overheating
Plastic
Fire rated V-0
Available Backcan (Sold Separately) UL Listed and Plenum rated
Warranty 1 year