OWI AMP-ER2TR6, Руководство пользователя

Страница: 15 / 20

OWI User Manual: Model AMP-ER2TR6
OWI INC. 15 www.owi-inc.com
INSTALLATION
NOTE: Installation is to be completed by a qualified electrical technician according to NEC/CEC code and
applicable local codes.
Installation Instructions for Speaker Combination Model AMP-ER2TR6
The AMP-ER2TR6 carton includes:
1. One (1) each AMP-ER2TR6 (In-ceiling 2 Source Amplified Speaker)
2. One (1) each UL Listed, Level 5 (Energy Star) Power Supply
(electrical wire not included)
3. Four (4) each Mounting screws
4. One (1) each cardboard mounting template
5. One (1) each User Manual
The AMP-ER2TR6 Combination carton includes items 1 to 5 above plus the following:
1. UL Listed 8 ohms in-ceiling speaker model IC6
2. UL Listed Backcan Enclosure (See Pages 17 & 18)
3. UL Listed Tile Bridge (See Pages 17 & 18)
*Note: Quantity of Ceiling speakers, tile bridge and backcan depends on the SKU of the AMP-ER2TR6
Combination Program.
Speaker Placement
Before installing your OWI speakers, consider the placement carefully, taking into effect the location of electrical,
plumbing and other fixtures.
Placement in Ceiling
OWI speakers should be located above the primary listening area.
Mounting your OWI speakers
Determine the best area to mount your OWI speakers. It will be necessary to run your speaker wires to that
location. This location must be free of obstructions, such as electrical conduits, HVAC ducts, or water lines.
Be sure the mounting surface is between 3/8 and 1 ¼ inches thick and that there is at least a 3 inch clearance
behind the mounting surface (5 inch if using an OWI backcan). Make sure that no objects block the back of the
speaker.
Remove the round cardboard disc from the template supplied and keep it for later use as a paint mask, if you
decide to paint your speakers.
Use the template to mark the position for the mounting hole at the selected location. If you are not certain that no
obstruction exists (electrical wiring, plumbing, etc.), you should start by cutting a small hole in the center of your
penciled mounting hole with a drywall or keyhole saw, cutting at a 45 degree angle towards the inside of the hole.
Cutting a small hole at this angle will make drywall repair much easier. Once you have determined there are no
obstructions in your desired mounting location, start cutting the finished hole at a 90 degree angle to the ceiling
surface.
Route the speaker wires from your amplifier to your opening. Avoid routing the speaker wire near electrical wires.
If you have to run them parallel, make certain to space the speaker wires at least 2 feet from the AC line. Do not
nail or staple the speaker wire.