12
Check in particular:
• that there are no signs or dents indicative of impact occurred during transport;
• that the supplied accessories are not damaged.
Damage reporting procedure
If any damage is found, stop the procedure in progress and report the nature of the
damage found to Rolland S.r.l.
NOTE
THE MANUFACTURER CANNOT BE HELD IN ANY CASE RESPON-
SIBLE FOR ACCIDENTS OR DAMAGE ARISING FROM THE USE OF
THE DEVICE IN AN ELECTRICAL SYSTEM THAT IS NOT COMPLIANT
WITH CURRENT REGULATIONS.
USE
Use procedures
Indications before use:
1. Insert the dome in the housing on the wooden base
2. Load the product into the dome using a pipette dropper*
3. Close the dome
4. Connect the power supply unit to the power outlet
5. Switch on the device by turning the metal knob/potentiometer
6. Adjust the diffusion intensity as desired
* The filling level must not exceed half the height of the internal component of the dome.
Troubleshooting
Should any unexpected or dangerous anomaly occur during a start-up and use phase of
the SEGNO electric diffuser, we recommend the following procedure:
1. Switch off the diffuser
2. Disconnect it from the electrical outlet
3. Check that the components have been assembled correctly
4. Switch on the device
5. Should the problem persist, unplug and, where possible, claim against the warranty.
POWER SUPPLY
