AirLive WIAS-3200N v2 User’s Manual
164
H
16.
Appendix H. Using STB
connector for power input
For any DC power input, you may use STB as power convertor.
Step 1.
Loosen the screw on top of the STB-male connector
Step 2.
Plug in the ground pin of your DC power into the right position hole of STB-male
connector (Shown as
Fig1.
)
Step 3.
Plug in the DC power into the left position hole of STB-male connector (Shown as
Fig1.
)
Step 4.
Tighten up the screw on top of the STB-male connector, makes sure the DC cable
has been fixed properly.
Step 5.
Insert the STB-female connector to the rear side of device (Shown as
Fig2
.)
*Note:
Check the DC power apply to STB connector fist, makes sure the DC power is
12VDC
Fig1.
Fig2.
