10400788-001 11/2017
©2016-17 Overland Storage
Page 2 of 4
SnapServer XSR40 Add-on/Spare DIMM Instructions
Remove the Front Bezel
1.
Carefully take hold of the
front bezel
and pull it straight
out from the appliance until it releases.
2.
Set the bezel
aside on a
secure surface
.
Remove the Drives
IMPORTANT: Overland recommends that you remove all the
drives to reduce the unit’s weight prior to rack removal.
1.
Press the release
button
on the drive carrier’s right side.
2.
Using the built-in
handle
, pull the carrier out.
Repeat this procedure for
all
the remaining carriers.
NOTE: Do not remove the drives from their carriers as doing so
voids the drive warranty.
Remove the Chassis from the Rack
WARNING:
It is recommended that a mechanical lifter (or at
least two people) be used during rack installation or removal to
prevent injury.
WARNUNG:
Um Verletzungen zu vermeiden, empfehlen wir zur
Rack-Installation oder -Deinstallation die Nutzung einer
mechanischen Hebehilfe (oder mindestens zwei Personen).
AVERTISSEMENT:
Pour éviter toute blessure il est
recommande qu'un monte-charge (ou deux personnes au
moins) soit utilisé lors de l'installation ou de l'enlèvement du
support.
1.
Based on the mounting system, with a
lifter
positioned in
front of the chassis, carefully remove the
chassis
from the
rack as follows:
• Fixed brackets
– Remove and retain the four
screws
with
slip nuts
from the brackets, and slide the
chassis
out onto the lifter.
• Sliding rails
– Release the front flange
captive
screws
, slide the
chassis
out until it stops, release the
rail
locks
, and slide the
chassis
onto the lifter.
2.
Move the chassis onto a
secure surface
.
Install/Replace the DIMM
Remove the Top Panel
1.
Loosen the
two captive screws
at the rear of the top
panel that secure it in place.
2.
Slide the panel rearward about
one-half inch
(1.25cm).
3.
Lift the
panel
off and set it aside.
1
2
3
4
Press
Fixed Brackets
Sliding Rails
Secure Surface
2 Screws
At Rear
