10400357-002 11/2017
©2014-17 Overland Storage
Page 3 of 4
SnapServer DX2 Add-on/Spare PCIe Card Instructions
Replace the PCIe Card
NOTE: If installing an additional PCIe
1.
At the rear (on top of the chassis wall), release and lift the
bracket lock
holding the cards in place.
2.
Grasp the existing
PCIe card
and carefully pull it
straight up and out of the slot, then set it aside.
3.
Insert the
new
PCIe
card
into the same slot, positioning
the card bracket in the rear bracket slot.
4.
Fold down and press the
bracket lock
until it clicks into
place.
Continue with
“Reinstall the Rear Top Panel.”
Install a New PCIe Card
Install the new PCIe
card in the next available PCIe slot on the
motherboard.
1.
At the rear (on top of the chassis wall), release and lift the
bracket lock
holding the cards in place.
2.
Insert the
new PCIe card
into the next empty slot on the
motherboard, positioning the card bracket in the rear
bracket slot.
3.
Fold down and press the
bracket lock
until it clicks into
place.
Reinstall the Rear Top Panel
1.
Position the rear top panel on the chassis with no more
than
one-half inch
(1.25cm) extending out over the rear
of the unit.
2.
Slide the panel
forward
until it is fully seated.
3.
Using the
four retained screws
, secure the panel.
Reinstall the Chassis in the Rack
Remount the Chassis
1.
Pull the
middle
rack rails out of the rack.
2.
Using the mechanical lifter, position the
chassis
in front
of the rack rails.
3.
Slide the chassis side rails into the rack rails, and push
the
chassis
all the way to the rear.
4.
Secure the chassis using the
two captive screws
on the
front flanges.
Bracket
Lock
Bracket
Lock
Screws
Screws
