Overland Storage REO 4600, Быстрый старт

Страница: 2 / 4

Part Number 10400252-101 01/2010
©2010 Overland Storage, Inc.
Page 2 of 4
Figure 3. Attach Inner Member to Expansion Unit
4. Repeat Step 3 to install the left inner member.
IMPORTANT: Depending on the type of rack you have, continue
with the Square-Holed, Round-Holed, or Round/Threaded-
Holed rack installation procedure.
Square-Holed Rack Installation
1. Attach left outer rail to the rack ( Figure 4 ) as follows:
Figure 4. Attaching Front of Rail
a. Position the rail against the inside of the rack front
rail with the hooks in line with the holes.
b. Insert the bracket front into the rack rail and press
down so that the hooks catch.
The spring-loaded tabs will extend into the hole to
prevent the rail from unhooking.
c. Slide the rear segment of the bracket rearward
until the hooks are in line with the correct holes.
d. Insert the bracket rear into the rack rail and press
down so that the hooks catch and the tabs lock.
2. Repeat Step 1 for the right slide rail assembly.
Continue with “Installing the Appliance in the Rack” on
page 3 .
Round-Holed Rack Installation (Early Models)
If the adapters in your rail kit resemble the
illustration to the right, use the following
procedure to install the adapters on the
outer rails before installing the rails in the
rack.
NOTE: These earlier adapters cannot be
used with threaded-hole racks.
1. Attach the left round-hole adaptor ( Figure 5 ) to the
outer rail:
Figure 5. Attach the Early Round-Hole Adaptors
a. Position the adaptor stamped “A” at the front of the
left outer rail.
NOTE: Make sure the A stamp is up and the two square
adaptor holes are aligned with the hooks on the outer rail.
b. Press the adaptor onto the hooks and slide it
upwards until it locks (clicks).
NOTE: The rail buttons will snap into the square holes.
c. Repeat Steps a–b for the rear adaptor (“B”).
2. Facing the rack ( Figure 6 ), position the left outer rail
on the left side of the rack, aligning the adaptor holes
with the front rack holes being used.
Figure 6. Using the Early Round-Hole Adaptors
3. Using the screws from the kit, secure the front of the
outer rail to the rack.
4. Slide the rear segment of the bracket rearward until
the adaptor holes are in line with the correct rack holes.
5. Using the screws from the kit, secure the rear of the
outer rail to the rack.
6. Repeat Steps 1–5 for the right outer rail .
Continue with “Installing the Appliance in the Rack” on
page 3 .
Round/Threaded-Holed Rack Installation
Install the adapters on the outer rails for
round-holed or threaded-holed racks before
installing the rails.
1. Attach the left round-hole adaptor
( Figure 7 ) to the outer rail:
Figure 7. Attach the Round-Hole Adaptors
Screw
Align Rear
Holes to Tabs
Hooks
Tab
Round-Hole
Adaptor
Round-Hole
Threaded
Rack Adaptor