Overland Storage REO 4600, Быстрый старт

Страница: 1 / 4

Part Number 10400252-101 01/2010
©2010 Overland Storage, Inc.
Page 1 of 4
REO 4600
Quick Start Guide
This document describes how to unpack and install an
Overland REO 4600 appliance into a standard RETMA 19"
rack. Each unit has a 2U form factor.
WARNING: To reduce the risk of electric shock or
damage to equipment, always remove the power cords
while installing or working on the appliance.
CAUTION: While working with the unit, observe standard
Electrostatic Discharge (ESD) precautions to prevent
damage to micro-circuitry or static-sensitive devices.
NOTE: When using the round-hole rail adapters, the collapsed
rails are only 28 in. (71cm) minimum instead of 26 in. (66cm).
First Things First—Activate Your Warranty!
Before installing your new unit, it is essential that you
activate your Overland warranty. Technical and warranty
support are not available until this is done:
1.
Go to the Overland Technical Support web site at:
http://support.overlandstorage.com/
2. At the MEMBER LOGIN ( Figure 1 ), log in to the site.
NOTE: If you are not yet a member, click the New member?
link and follow the instructions. It’s free and easy!
Figure 1. MEMBER LOGIN Section
3. At the Support Home page menu on the left, select My
Products > Add or Register a Product .
4. Fill in the information and click Submit .
Rack Installation
WARNING: Install multiple units from the bottom up.
Extending a unit out of a rack that has empty spaces
beneath it might cause the rack to tip over.
The rail kit included with the expansion unit is adaptable
for installation in the major types of hardware racks:
• Squared-holed RETMA rack
• Round-holed RETMA rack
• Round/Threaded-holed RETMA rack
NOTE: The two-post telco-style rack or a rack less than 32-
inches in depth will not support the expansion unit.
The rails are not universal. They are stamped LH (left)
and RH (right) and must be mounted on the appropriate
side (when facing the rack front).
Attach Inner Rails to Chassis
This procedure is required for all rack types :
1. Fully extend the rails, push the latch on the inner
member down, and remove the
inner rail ( Figure 2 ).
Release and slide the middle member back in.
Figure 2. Inner Rail Release Latch
2.
Identify and mark the screw holes on the rack where
the sliding rails will be installed.
NOTE: Be sure rear holes are horizontally in line with the
front holes to assure the unit remains level.
3. Attach the right inner rail ( Figure 3 on page 2 ) as
follows:
a. Position the rail against the expansion unit with the
locking tabs going through the holes on the rail.
b. Slide the rail toward the front to lock it.
c. Secure the rail with a screw .
Inner Member Latch
Middle Member Latch
(Hidden)
Middle Member
Outer Member