Figure 5
Figure 7
the strap and then the lid from the battery
holster to place a 12-volt battery inside.
7. Slide the ramp extensions onto the main
ramp. The mid ramp extension slides on
fi rst (Figure 6). The illustration on page 3
shows these as 61-6152 (mid extension)
and 61-6153 (end extension).
8. Insert the ½-inch pins (229-0520). One
pin fastens the mid ramp and end ramp
extensions to each other. The other pin
fastens this assembled ramp extension to
the main ramp. Figure 7 shows the ramp
extensions fastened with the ½-inch pin.
9. Attach corded control (Figure 8) to the
electrical connection near the battery and
motor. Make sure the cord is away from
ALL
moving parts. If it is
NOT
clear of the
rack, damage could occur.
1. While using the corded control, hold the
ramp to prevent uncontrolled tilting of the
SportLoader. Press the button to start
Be sure to install the 2 tethered pins
and clips in the ramps.
FAILING
to do
so could result in personal injury and/or
property damage. (Figure 7
)
KEEP YOUR HANDS AWAY
FROM MOVING PARTS.
Make sure area around the
SportLoader
TM
is clear of all
bystanders. The operator is the only
person who needs to hold the ramp so
it does
NOT
slam into the ground or
truck bed when operated.
!
CAUTION
Figure 6
Figure 8
Page 5 of 7
Loading
09/06