oventrop Regtronic RH HT, Инструкция по установке и эксплуатации для специализированного инсталлятора, Страница: 15 / 56

Installation
15
Commissioning
Settings
Tr
oubleshooting
Data comm
unication
en
4.1 Schemes with basic settings
The controller is preprogrammed for several basic systems. The basic pre-ad-
justments have already been made. The selectable schemes can be found in the
appendix of the "Regudis H-HT" manual.
Relay and sensor allocations correspond to the figures.
Scheme 0 has no pre-adjustments.
4.2 Step-by-step parameterisation
The heating controller Regtronic RH is a controller that offers a broad variety of
functions to the user. At the same time, the user has a lot of freedom in configu-
rating them. Therefore, to set up a complex system, careful planning is required.
We recommend drawing a sketch of the system first.
If planning, hydraulic construction and electrical connection have all been carried
out successfully, proceed as follows:
1. Running the commissioning menu
After the commissioning menu has been finished (see page 13), further adjust-
ments can be made. The commissioning menu can be repeated any time by means
of a reset (see page 43). Additional adjustments will be deleted.
2. Registering modules and sensors
If an impulse flow rate sensor, a switch, Grundfos Direct Sensors™ and/or ex-
ternal extension modules are connected, these have to be registered in the In-/
Outputs menu.
For further information about the registration of modules and sensors see page
46.
3. Adjusting heating circuits and activating optional heating functions
Now, further heating circuits can be activated and adjusted.
For the heating part of the arrangement, optional functions can be selected, acti-
vated and adjusted.
• DHW heating
• Circulation
• Thermal disinfection
Heating circuits and their optional functions can use shared relays for (boiler)
demands, loading pumps or valves. They have to be selected in the Shared relays
menu first (see page 18). All free relays available on the controller and on the
modules connected can be used.
The controller always suggests the numerically smallest free relay.
Sensors can be allocated to more than one function.
For further information about heating circuits and optional heating functions see
page 29.
4. Adjusting the operating mode
After commissioning the heating circuit will be in automatic mode. The operating
mode can be changed in the status menu:
• Automatic
• Day
• Night
• Summer
• Holiday
• Off
The operating mode of the first heating circuit also applies to all further heating
circuits (via extension modules), if they are linked. If you wish to operate one of
the heating circuits 2 … 7 independently, deactivate the linking of the correspond-
ing heating circuit (see page 27).
5. Activating optional arrangement functions
Now, optional functions for the arrangement can be selected, activated and ad-
justed:
• Heat exchange
• Return preheating
• Solid fuel boiler
• Mixer
• Parallel relay
• Irradiation switch
• Zone loading
• Error relay
• Function block
Free relays can be allocated to optional functions which require a relay. The con-
troller always suggests the numerically smallest free relay.
Sensors can be allocated to more than one function.
For further information about the optional arrangement functions see page 35.