Heat meter connection set
Installation
6. Installation
CAUTION
Risk of scalding due to hot media!
If the system was in operation, there is a risk
of scalding due to unintentional discharge of
hot water or steam.
!
Allow the system to cool down.
!
Wear safety goggles.
CAUTION
Risk of burns due to hot components!
Touching hot components can cause burns.
!
Wear safety gloves.
NOTICE
Damage to property due to lubricants
Seals can be destroyed by the use of greases
or oils.
!
Do not use greases or oils during
installation.
!
If necessary, flush dirt particles and
grease and oil residues out of the
pipework.
6.1
Installation of the heating circuit
distributor/collector
The heat meter connection sets are suitable
for left and right hand side connection to
the heating circuit distributor/collector.
f
Install the heating circuit distributor/
collector in the cabinet according to the
enclosed instructions.
When using a heat meter, mount the return
collector at the top and the flow distributor
at the bottom in the bracket!
For installation of the heat meter, see par.
We recommend the installation of a strainer
to ensure the proper functioning of the
components of your heating system in the
long term.
6.2 Installation of the heat meter
connection set
In this example, the left hand side
connection is shown.
Observe the instructions for conversion for
right hand side connection in the
instructions for your heating circuit
distributor/collector.
Fig. 5: Installation example for the angle version
of the heat meter connection set
Fig. 6: Installation example for the straight
version of the heat meter connection set
1.
Install the components (for left hand side
connection) as shown in Fig. 5 on page
24 or Fig. 6 on page 24. Use the
enclosed flat seals.
2.
Tighten all connections firmly.
24
140488480-V01.10.2021
