Ovation POWER PAR 350 TW, Руководство пользователя

Страница: 6 / 12

6 V1.0 www.ovationlight.com
1. Group
2. Signal (-)
3. Signal (+)
DMX OUT
1. Group
2. Signal (-)
3. Signal (+)
DMX IN
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture.
Always connect one output with the input of the next fixture until all fixtures are connected.
DMX-512 connection with DMX terminator:
For installations where the DMX cable has to run a long distance or is in an electrically noisy environ -
ment, such as in a discotheque, it is recommended to use a DMX terminator. This helps in preventing
corruption of the digital control signal by electrical noise. The DMX terminator is simply an XLR plug with
a 120 resistor connected between pins 2 and 3, which is then plugged into the output XLR socket of the
last fixture in the chain.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120 Ω re -
sistor between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last
fixture.
Power connection
Power Requirements
The Power Par 350 TW luminaire operates on 100 to 240 volts AC (+/- 10%, auto-ranging). The lumi-
naire contains an auto-ranging power supply.
On the rear panel, there is a lockable powercon out. Connect the output with the mains input of the next
fixture until all fixtures are connected.
Note:
A maximum of 8 fixtures can be linked together. After every 8 fixtures, the units must have a re -
newed connection with the power mains.
Connection with the mains:
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection cables as below:
Cable color Connection International
Brown Live L
Blue Neutral N
Yellow/green Earth(Ground)
Operation
The Power Par 350 TW can operate in different modes. In each mode you can run the fixture as a stand
alone fixture or in a master/slave confiugration. This next section will detail the differences in the operat
-