6
V1.0
hotion.com
Addressing
All fixtures should be given a DMX starting address when using a DMX signal, so that the correct fixture
responds to the correct control signals. This digital starting address is the channel number from which
the fixture starts to listen to the digital control information sent out from the DMX controller. The allo
-
cation of this starting address is achieved by setting the correct number on the display located on the
base of the device.
You can set the same starting address for all fixtures or a group of fixtures, or make different address
for each fixture individually.
If you set the same address, all the units will start to listen to the same control signal from the same
channel number. In other words, changing the settings of one channel will affect all the fixtures simulta
-
neously.
If you set a different address, each unit will start to listen to the channel number you have set, based on
the quantity of control channels of the unit. That means changing the settings of one channel will af
-
fect only the selected fixture.
In the case of the Panto Leko 60 , which is 1/2/3/5 channels fixture. If you set, for example, the address
in the 2 channel mode to channel 2, the device will use the channel 2 to channel 3 for control.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or
not. If there is data received at the DMX input, the dot in the display will flash.
Universal DMX Control
This function allows you to use a universal DMX-512 controller to control the dimmer and strobe. A
DMX controller allows you to create unique programs tailored to your individual needs.
Zoom
This function allows you to adjust the beam width of the
fixture.
Step 1: Loosen the zoom buttons on the side of the device.
Step 2: Adjust the zoom by sliding the zoom knob forward
or backward.
Step 3: Adjust the focus by sliding the focus knob forward
or backward.
Step 4: Tighten the zoom and focus buttons.
Focus
Zoom
