Inverter
2 Prong Plug
Outwater Plastics Industries Inc.
1-800-631-8375 • www.outwater.com
Getting Started
Tool
When cutting MAXX LED Flex section, use a straight edge cutter with
an anvil such as Outwater item #: CL46-25.
Hint: We are looking for a square, clean cut.
DO NOT use scissors, hand saw or utility knife to cut.
In the event of an uneven cut, do not try to repair and instead advance to the next appropriate section.
Thank you for purchasing MAXX LED Flex.
To ensure proper installation, release read & follow these guide lines
1. This product has been rigorously tested and has passed our quality control prior to shipping.
2. Test MAXX LED Flex within 48 hours upon receipt to make sure no damage occurred during shipping.
3. Important during your inspection do not leave MAXX LED Flex coiled and plugged in for more then 1-2 minutes.
Excessive heat build up may damage the electronics and shorten the life.
4. Each roll of includes a factory installed waterproof power cord and has a 1 year limited warranty.
5. Customers wishing to cut or alter MAXX LED Flex, must follow the guide lines.
Note: Cutting voids all warranty. Customers wishing to have pre cut sections please call our sales department.
Minimums and lead times apply.
Standard Solid Color
Economy Solid Color
Guide Lines
Important Cutting Instructions: Only cut 120V Ribbon at appropriate junctions as seen in diagram
Helpful Hint: The tendency is to cut right in the middle or straight in half instead, it is recommended to cut
closer to the finished end where you will attach an end cap. This allows more room to attach the power
cord to the next section.
The proper installation begins with a straight cut & the precise alignment of power cord to the MAXX LED Flex.
Measure & Cut 120V LED Ribbon To Desired Length
Cut line closer
to ending side
Cutting Area
Cutting Area
Bulletin: 7-10-19
Connecting
Cables
Hardwiring To A
Wall Switch / Dimmer
Customers wishing to create gaps over doorways
or turns may require a connecting cable.
The installation is the same as connecting the
MAXX LED Flex to a power supply.
Have your electrician remove the 2 prong plug and hardwire to
your switch.
Note: Must not remove the inverter
Front view for cutting
Back view for cutting
