Outsunny 840-213, Инструкция по установке и эксплуатации

Страница: 16 / 16

Press the extension bu�on "EXT" for
the awning extension. The role moves up and
the awning will be extended.
Press the retract bu�on "RET" to close
the awning. The role moves down and the
awning will be retracted.
Press the stop bu�on "STOP" to stop
the extension/ retrac�on of the awning.
Drawing 8. 2:
remotel control
A�en�on: Please ensure a qualified person with electrical proficiency does the installa�on to ensure correct opera�on and be safe.
Electrical Connec�on Guide
This awning required hard wire connec�on to mains power, please ensure you follow the diagram below to connect.
Extend and retract the awning
The awning can be extended and retracted by a crank handle included in delivery or remote control.
Drawing 8. 1:
Insert the handle in the loop
that is fixed at the awning.
Open the awning by turning
the crank handle clockwise.
By turning it
counter-clockwise you can
retract the awning.
8.2 8.1
Engine se�ng(off/on se�ng)
Factory default se�ng is best for the engine .Larger se�ngs before its use should therefore not be necessary.
In the following cases, however, the engine should be a bit readjusted if:
1 The awning doesn`t close completely.
2 The cover is loose.
3 The engine is not running yet, although the awning is fully closed.
•Change the maximum distance of the awning, by using the enclosed tool. Use the motor adjustment tool to adjust the motor ,.
•Use the front motor adjustment screw to adjust the maximum distance (see Figure M).
•Turn the adjustment screw with the tool in counterclockwise direc�on "+" to increase the maximum distance.
•Turn the adjustment screw with the tool 20 in a clockwise direc�on "-" to reduce the maximum distance.
•Use the rear adjustment screw to adjust the minimum distance(see Figure N).
•Turn the adjustment screw with the tool in counter-clockwise direc�on "+" in order to increase the minimum distance.
•Turn the adjustment screw with the tool in clockwise direc�on "-" to reduce the minimum distance.
NOTE: If the motor does not start on a�er repeated on se�ng, please wait 30 minutes and start it again a�erwards.
NOTE: Over loading the motor is not good. Doing so may shorten its lifespan.
Handling of the remote control
Note: There are legal limita�ons for the transmission range of radio waves. The maximum range is
also limited by physical obstacles.
•Before installing, check whether the remote device and the awning are working correctly ,Before you install the hooks .
To allow reaching almost every ver�cal area below.
Make sure that the mount is in a place to install the corresponding prescribed protec�on (IP 20) of the remote .
•Do not mount on metal or magne�c objects to avoid interference.
Ba�ery/Use
NOTE: When you insert the ba�ery make sure that the contacts are not bent.
•Open the ba�ery compartment with the spanner in the ba�ery compartment lid in the direc�on
of the ba�ery compartment and press the ba�ery compartment cover , then the ba�ery compartment slides.
•Put the ba�ery in accordance with polarity and labeling in the ba�ery
•Close the ba�ery compartment , by clicking the two extensions of the ba�ery compartment lid in the two cutouts on the
ba�ery compartment .
•Then press the skewer of the ba�ery compartment lid into the hole at the ba�ery compartment .
The ba�ery compartment cover snaps in with a click.
•If the remote control could not func�on, then check whether the ba�eries are inserted correctly and put them again if necessary.
Maintenance
Regular maintenance will not only help to keep a long durability but it is also important for your own and the safety of other people.
•Examine regularly whether wall brackets are �ght, if not, fasten them.
•Examine the gear box once half a year. If you find any damages, stop using un�l gear box has been repaired or renewed.
•Examine the bolts and nuts once half a year, fasten them if loose or lax.
•Stop using the awning immediately if it is has been damaged or it is not �ghten properly.
16