professional instruments
ET1.1-ST2 Electronic turntable
page 7
outline s.n.c. di noselli g. & c. - v. leonardo da vinci, 56 - 25020 flero (bs) - italy - tel. +39-30-3581341 fax +39-30-3580431
Web Site:
http://www.outline.it
E-Mail :
Accessories
•
On request is available an adjustable support stand for small loudspeakers in size useful to get the measures
in the middle height of the room, far as possible from the reflections.
•
It is also available on request a cable adapter to manage at the same time two electronic control ET1.1 with the
ET Commader program supplied.
ET1.1 (or ET1 upgraded) connections
1) Measurement cards (LMS, MLSSA, CLIO,
TEF).
Pin 1, 3, 6, 7, 8, 9 : not connected
Pin 2 : start pulse
Pin 4 : ground
Pin 5 : return pulse
2) ST2 (ST1) master turntable
Pin 2, 7, 8 : not connected
Pin 1 : Vss motor
Pin 3 : + 12V
Pin 4 : Gnd
Pin 5 : step control
Pin 6 : Vdd motor
Pin 9 : zero position control
3) PC control. It is supplied a parallel adapter
to use Outline ET Commander.
See “Control protocol”
4) ST2 (ST1) slave turntable. This must always
used with a ST2 master turntable.
Pin 2, 3, 4, 5, 7, 8, 9 : non connected
Pin 1 : Vss motor
Pin 6 : Vdd motor
ST2 (ST1) connection
ST2 (ST1) master turntable
Pin 1 : Vdd motor
Pin 2 : Vss motor
Pin 3 : + 12V
Pin 4 : Gnd
Pin 5 : step control
Pin 6 : zero position control
ST1 turntable
MASTER
Measurement card
(LMS, MLSSA,
CLIO, TEF)
ST1 turntable
SLAVE (reverse)
Control from
PC
1
2
3
4
