ASSEMBLY INSTRUCTIONS :
IMPORTANT: It is advisable to assemble the tent once before going camping to ensure
that all parts are present and to become familiar with the assembly of the tent.
Step 1 - Lay out the tent
Select a sheltered camp site protected from the wind that will not allow water to pond under the tent floor.
Clear a level area of all stones, twigs, etc.
Lay out tent with doors facing the desired direction.
Open doors to allow air inside when standing tent up.
Join the duraluminum poles together ensuring each section is firmly secured into the next.
Step 2 - Install the poles
-
Slide the assembled pole through the sleeve in the tent ( see figure 3 ). Gently raise the tent and place the
ends of the pole onto the pins ( see figure 2 ) on opposite ends across the tent. The tent should stand up
during this action ( see figure 3 )
- Attach the J-Hooks to the poles ( see figure 3 )
WARNING:
Do not force pole through the sleeves as this may damage the sleeve and could break the pole.
Check to ensure the pole does not snag when sliding it through the sleeve.
Step 3 - Peg down the tent
Peg the tent to the ground by driving pegs through the rings at the base of the poles.
Firm but not tight. Ensure all other peg down points are utilised.
Step 4 - Install the rain fly
Place the fly over the tent.
Secure fly by attaching the velcro inside the fly to the pole.
Attach the buckles on the fly to the tent at the base of the poles.
Peg down the remaining peg loops on fly sheet.
Peg out the guy ropes attached to the fly, peg out as far as possible from tent.
Ensure all peg down points are utilised and all guy ropes are attached firmly and remain firm
(
see figure 4
)
.
Open side entrances on the fly as required.
