INSTALLATION
The recommended installation position is up-right as shown
in Fig 2, view "D". It has two (2) inlet and two (2) outlet gas
connections. The diagrams below provide possible ways to
plumb the E-Stop (See Fig. 3). Two (2) ½” NPT plugs are
provided with the E-Stop. Plug the inlet and outlet
connections not being used for the application. Connect gas
supply to the inlet with the arrow pointing into the
valve. Connect outlet side to the gas appliance (See Figs. 2 &
3 for details).
NOTE:
Conduct a gas leak test on the E-Stop Gas Timer after
plumbing is complete.
OPERATION
TO TURN ON
Step 1
: Rotate the clear timer dial past 20 (ESTOP1-0H) or
past 0.5 (ESTOP2-5H) to set the time. Timer will begin
“ticking” when the dial is turned while the countdown time
is set.
Step 2:
Turn red knob clockwise (about a ¼ turn)
until it pops outward. Gas will now flow to enable you to
light the appliance.
TO TURN OFF:
Let timer expire or simply press red knob inward until it
stops. The red knob will lock down with a “click” and stop
gas flow. See Fig. 4 and Fig. 5 on following page.
Note:
Do not force the timer dial to the OFF position after
time is set
(This will weaken the spring inside the timer body
and affect the accuracy of the time).
Timer Dial
:
Rotate clockwise to
start time. Adjust dial
to desired time frame.
Red Knob:
Turn clockwise and
knob will “pop” up
to allow gas flow.
PUSH TO STOP
TURN TO START
OFF
TURN
PAST
20
40
60
MINUTES
Fig. 4
E-Stop operation.
BACK VIEW
Inlet
Inlet
Outlet
Outlet
SIDE IN
SIDE OUT
BACK
IN
BACK
OUT
Fig. 2
Inlet and outlet connections.
“A-C” Shows Top View of E-Stop
Inlet
Outlet
D
“D” Shows Front View of
E-Stop
PUSH TO STOP
TURN TO START
OFF
TURN
PAST
20
40
60
MINUTES
Inlet
Outlet
C
Inlet
Outlet
B
Inlet
Outlet
A
Fig. 3
Plumbing options
www.TheOutdoorPlus.com
Page 3
909-460-5579
