www.desatech.com
121450-01A
2
Align holes in bottom edges of cabinet base with holes in base.
Attach with 1 screw (C), 1 washer (D) and 1 nut (E) for each of
the 9 holes. Set assembly upright.
ASSEmbLy
Estimated assembly time: 60 minutes
Tools required:
• #2 Phillips screwdriver
• 1/2", 5/16" and 7/32" Open end wrenches
Hardware packet provided with heater may contain more parts than
needed for heater assembly.
Hardware packet contains the following items shown on pages 8
through 11 in your owner's manual):
Electronic Ignitor (1), Ignitor Wire (1), Ground Wire (1), Valve Knob
(1), Propane Tank Retention Chain (1), Retention Hook (2), D Bat-
teries (2) and AA Battery (1).
Base assemBly
1. Connect 2 base parts using 5 screws (C), 5 washers (D) and 5
nuts (E).
Parts are referenced by designated letter throughout assembly
instructions. Hardware packet contains the following (quantity used
in parenthesis):
Description
Part No.
A 2
1
/
4
" Hex Bolt (2)
HC4-18C
B 12 mm Hex Nut (2)
NPC-5C
C 5/8" Screw (14)
119619-03
D 5 mm Washer (14)
119600-02
E 5/16" Hex Nut (14)
NPC-3C
F 3/8" Screw (20)
119619-06
G 7/32" Hex Nut (20)
NPC-1C
H 3/8" Self tapping screw (34) 119620-02
F
H
B
C
D
E
G
A
3. Being careful not to scratch paint, lay cabinet base onto back side
(use foam packaging block to support rear top of cabinet base).
2. Turn base upside down. Attach 2 wheels, 2 hex bolts (A) and 2
nuts (B). Do not overtighten.
Nut
Washer
Screw
