6
Burner Installation (WP-1616)
1.
Attach Natural Gas supply line or included black rubber
propane hose/regulator (depending on gas type) to
control valve.
TIGHTEN CONNECTIONS SECURELY WITH TWO WRENCHES
Ensure all connections are secure and leak free before using fire pit.
2.
Lay the burner upside down on a flat, soft surface to
avoid scratching the metal trim. Ensure the correct
orifice is installed for the fuel type you are using (see
Crystal Fire user manual included with burner for
orifice sizing information). Attach the included metal
flex hose to the burner.
Read and understand your Crystal Fire owner’s manual before
beginning burner hookups or using the device.
Do not use Teflon tape or pipe sealant on flare fittings.
Propane or
Natural Gas
input
or
Natural gas supply line
as specified by local
building codes
11
Burner Installation (WP-INT)
1.
Remove existing control panel from base:
a.
Use a Philips head screw driver to remove the
4 screws.
2.
Replace existing control panel with intrigue control
panel:
a.
Use a Philips head screw driver to replace the
four screws in the four corners of the control
panel.
3.
Assemble INT-EZ with burner trim.
Refer to INT-EZ
manual before attempting to install.
Read and understand your INT-EZ owner’s manual before
beginning burner installation or using the device.
IMPORTANT
Please consult your INT-EZ instruction manual for detailed instructions
and important information related to burner installation, including:
lighting and operating instructions, and safety information.
DO NOT ATTEMPT TO INSTALL INT-EZ BURNER WITHOUT FIRST
CONSULTING THE INT-EZ OWNER’S MANUAL.
