6
MAINTENANCE
WARNING:
ALWAYS DISCONNECT POWER BEFORE SERVICING.
DO NOT IMMERSE HEATER IN WATER!
Always turn OFF the heater and disconnect power before cleaning your heater.
Light accumulated dust may be removed from the heater with a soft cloth or vacuum cleaner.
Wipe the exterior surfaces of the heater occasionally with a slightly damp cloth (not dripping
wet) using a solution of mild detergent and water. Dry the case thoroughly before operating the
heater.
Caution:
Do not allow water to run into the interior of the heater as this could create a fire or electric
shock hazard.
The fan motor is factory lubricated for life and will not require further lubrication.
Store heater in a clean dry place when not in use.
Warning:
Any other servicing needed must be performed by an authorized service representative.
Do not attempt to service the unit yourself.
OPERATING INSTRUCTION
This appliance can be operated by both remote control and manual button. Once the unit has been
properly connected to a grounded electrical outlet, a beep should be heard and the power is first
applied.
CAUTION! The unit’s power cord must be connected to a properly grounded and protected
120V outlet. Always use ground fault protection where required by the electrical code.
WARNING! Do not operate the unit if it is damaged or has malfunctioned. If you suspect the
unit is damaged, please call a qualified service technician to inspect and to
replace any part of the electrical system If necessary.
●
Operating by Manual Button
NOTE!
The manual buttons on the fireplace unit do not provide you with all function controls, its
purpose is to control some basic function if you lose the remote handset. Please use the remote
handset to carry out all functions.
FLAME BUTTON
HEATER BUTTON
MAIN POWER SWITCH
figure 5
