WARNINGS
REGULATOR HOSE ASSEMBLY CHECK:
WARNING
Before each use, check to see if there is evidence of abrasion, wear, cuts or leaks on the hose. If
damage is evident, the hose must be replaced prior to appliance use.
DISCONNECTING REGULATOR FROM THE LP TANK:
•Turn control knob to the OFF position.
•Turn LP tank OFF by turning hand wheel clockwise to a full stop.
•Turn the coupling nut counterclockwise to loosen the connector.
NOTE:
Loosen by hand only. DO NOT use tools.
•When disconnected, the regulator should be hung on the hook
attached to the appliance.
INSTRUCTIONS FOR LIGHTING BURNER:
•Read and understand all instructions and warnings before lighting. Only light burner outdoors.
•Confirm that the regulator control valve and LP cylinder is completely closed and in the “OFF”
position.
•Ensure a minimum of 24 inches separate the LP tank and the burner. Note that the LP hose is a
tripping hazard and special care must be observed.
•Open the LP cylinder valve fully by turning counter clockwise.
•Ensure that nothing is directly over the burner. DO NOT allow your head or arms to ever be above
the burner.
•Use an extended reach lighter or an ignited long match and allow flame to be placed directly over
the burner. Slowly turn the regulator control valve on and adjust flame .
•If the burner does not light within five (5) seconds, turn the regulator control valve back to the
“OFF” position, re-close the LP tank valve and wait five (5) minutes. After waiting five (5) minutes,
re-start the process from step one (1) above.
DANGER
NEVER allow this appliance to operate unattended. Failure to follow this Danger Statement
could result in fire, explosion or burn hazard that could cause property damage, personal injury
or even death. If a fire should occur, keep away from the appliance, move everyone to safety
and immediately contact the fire department and emergency personal (e.g 911). ALWAYS
have an appropriately rated fire extinguisher on hand when using this product. A Class “B” dry
chemical OR CO2 extinguisher or preferably a Class “K” extinguisher. Special care must be
taken to understand the manufacturers instructions and be prepared to operate the appropriate
extinguisher prior to using this appliance
.
Page 7 of 23
