Recommended:
Hammer,
Carpenter’s square, Clamp, Tape measure
1/2" Wrench
Power drill with #2 Phillips bit
6
'
PICNIC TABLE KIT ASSEMBLY INSTRUCTIONS
©2018 Universal Forest Products, Inc. Assembled in the USA with imported fasteners. All rights reserved. 2801 East Beltline NE, Grand Rapids, MI 49525 800.598.9663 10211_9/18
Outdoor Essentials is a registered trademark of Universal Forest Products, Inc.
OutdoorEssentialProducts.com
PARTS LIST
BEFORE YOU BEGIN
TOOLS YOU WILL NEED
A
D
E
C
4 – Table Legs
1 – Tabletop*
2 – Bench Seats*
2 – Diagonal Braces
2 – Bench Supports*
8 – Hex Nuts
8 – Carriage
Bolts
8 – Washers
32 – 2-1/2"
Screws
ASSEMBLY
B
F
H
G
I
6
'
PICNIC TABLE KIT ASSEMBLY INSTRUCTIONS
©2019 Universal Forest Products, Inc. All rights reserved. 2801 East Beltline NE, Grand Rapids, MI 49525 10211_3/19
Outdoor Essentials is a registered trademark of Universal Forest Products, Inc.
OutdoorEssentialProducts.com
PARTS LIST
ASSEMBLY
H
I
THE DIAGRAMS AND INSTRUCTIONS IN THIS BROCHURE ARE FOR ILLUSTRATION PURPOSES ONLY AND ARE NOT MEANT TO RE-
PLACE A LICENSED PROFESSIONAL. ANY CONSTRUCTION OR USE OF THE PRODUCT MUST BE IN ACCORDANCE WITH ALL LOCAL
ZONING AND/OR BUILDING CODES. THE CONSUMER ASSUMES ALL RISKS AND LIABILITY ASSOCIATED WITH THE CONSTRUCTION
OR USE OF THIS PRODUCT. THE CONSUMER OR CONTRACTOR SHOULD TAKE ALL NECESSARY STEPS TO ENSURE THE SAFETY
OF EVERYONE INVOLVED IN THE PROJECT, INCLUDING, BUT NOT LIMITED TO, WEARING THE APPROPRIATE SAFETY EQUIPMENT.
EXCEPT AS CONTAINED IN THE WRITTEN LIMITED WARRANTY, THE WARRANTOR DOES NOT PROVIDE ANY OTHER WARRANTY,
EITHER EXPRESS OR IMPLIED, AND SHALL NOT BE LIABLE FOR ANY DAMAGES, INCLUDING CONSEQUENTIAL DAMAGES. FOR
DETAILS ON SAFE HANDLING AND WARRANTY INFORMATION, GO TO
UFPI.COM/PTINFO.
cleat
* If your bench supports have beveled
corners, be sure they face downward.
PRO TIPS
Use a hammer to fully seat bolts
into holes
PRO TIP
Flush
Flush
Continuous water absorption and water loss in the wood can cause its natural defects to
surface. To reduce the appearance of these natural defects and extend the life of your picnic
table, apply a protective fi nish such as a semitransparent stain or waterproofi ng sealer.
The table has approximately 86 square feet of surface area. Apply the fi nish following the
stain or sealer manufacturer’s instructions and reapply every two years as needed.
PRO TIPS
Check out our blog to learn more about
fi nishing your picnic table, along with
other projects!
OE.media/blog
Connect with us:
@OutdoorEssentialProducts
@outdoor_essentials
Mold occurs naturally on wood. If you receive a picnic table with mold on it,
you can safely clean it with water and detergent or vinegar.
2 PEOPLE
1 HOUR
MINUTES
45
View our installation video at
OE.media/table
This table is made from construction grade lumber and
may contain rough edges. Wear protective gear.
2 PEOPLE
1 HOUR
MINUTES
45
It will take you about 45 minutes to complete.
You’ll need
two adults
to safely assemble this picnic table.
C
C
C
C
B
B
B
B
C
- Center legs on tabletop
- Hold legs tight to the cleat
and tabletop
- Drive in screws
- Clamp legs to cleat
before drilling
- Predrill holes before
drilling in screws
1
3
5
4
2
Insert bolts into bench supports
Attach legs to tabletop with screws
Attach bench seats with screws
Attach diagonal braces with screws
Attach legs to bench supports*
CARE AND MAINTENANCE
Do not fully
tighten Hex nuts
*Your kit may include parts with beveled corners.
E
B
H
H
H
B
C
A
D
I
I
C
C
A
B
B
I
I
I
C
F
F
G
G
H
H
PRO TIP
Use a carpenter’s
square to confi rm
legs are square
before drilling the
diagonal brace in
place.
Fully tighten
Hex nuts
before
drilling the diagonal
brace in place.
Center the brace
Flip table up
2 PEOPLE
1 HOUR
MINUTES
45
PRO TIP
Use a tape
measure to
confi rm bench
is centered.
