RCPR96
INSTALLATION OF ‘OUTBACK’ ROOF CONSOLE
PRADO 90 series 7/96 – 8/02
Part No. RCPR96
Failure to connect coloured wiring correctly and tape up all connections as described in following
instructions will result in an electrical short and void console warranty.
For this installation you will need a
hand held
Phillips screwdriver, steel ruler and insulation tape.
VEHICLE PREPARATION:
Swing Sun Visors around to side and lay flat to roof for ease of installation.
Switch interior light to off position, remove from roof, disconnect wiring and put aside, retain screws for fitting.
Remove the rear view mirror; use steel ruler to lever plastic cover off sideways and undo the two screws
beneath.
Remove the map lights; slide steel ruler (lever tool) in from the front, between light housing and roof lining; at
a position 60mm in from each end and lever downwards to remove cover and repeat to remove light housing.
No damage can be caused as the lights are simply held in with spring loaded clips. Unplug wires, tuck wires
and plug back into void in roof. Put lights aside for reinstallation upon sale of vehicle.
Rear Fixing Plate Installation:
Using a
hand held
Phillips screwdriver
fasten Rear Fixing Plate to the two vacant interior light screw holes.
Use original interior light screws and fasten plate through
marked
holes
ensuring captive nuts are to
front
of vehicle and interior light
plug protrudes out side of plate. Fasten
yellow
earth wire supplied
to one of these screws.
Front Mounting Bracket Installation:
Fasten Front Mounting Bracket
supplied to
inside
front of Roof Console using two (2) 6mm x 16mm
black
Phillips round head bolts supplied.
1
4
1
4
1
4
CAPTIVE NUTS TO FRONT OF VEHICLE
