Part Replacement Instructions
900-0107-01-00 Rev A
3
6.
Using a #2 Phillips screwdriver, remove the 6 screws located in the AC wiring compartment. See Figure 3.
Figure 3
AC Compartment Screws
7.
Using the 4mm hex wrench, remove all 8 hex bolts that connect the top cover to the bottom chassis of
the inverter. The locations of these bolts are shown in Figure 4.
IMPORTANT:
After removing the hex bolts, read the next step carefully before removing the cover.
CAUTION: Equipment Damage
Inverter components will be damaged if the cover is removed too quickly. The cover
and fan are wired to the internal FET board with a PCB connector. See Figure 5.
Figure 4
Top Cover Hex Bolts
8.
Carefully lift the inverter cover, just far enough to locate the fan wire.
Screws
