Outback Power PSX-240 User’s Guide
PSX-240 User’s Guide
Page 2
P/N: 900-0043-1
Rev. A – Released 4/25/2005
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS!
This manual contains important instructions for the OutBack
PSX-240
Autotransformer.
All of the AC wiring to the circuit breakers terminals is to be torqued according to the torque specs in the
Mechanical Installation section of this manual
. Wiring to these terminals must meet requirements of the National
Electric Code (NEC). The terminals will accept up to 10AWG. Use copper conductors only with insulation rated for 75˚
C. See the AC WIRING CONNECTIONS section of this manual for more information.
1
For equipment grounding hook up, see the system configuration sections in this manual. This product is
intended to be installed as part of a permanently grounded electrical system per the NEC.
2
Installation must be performed by a licensed installer familiar with local and national wiring codes.
3
The equipment ground on the PSX-240 is marked with this symbol:
GENERAL PRECAUTIONS
1.
Before using the PSX-240, read all instructions and cautionary markings on (1) the PSX-240 and (2) all
appropriate sections of this installation and operation manual.
2.
The PSX-240 is approved for indoor mounting only in any position.
3.
Do not disassemble the PSX-240. Refer servicing to a qualified service center when service or repair is
required. Incorrect re-assembly may result in a risk of electric shock or fire. To reduce risk of electric shock,
disconnect all wiring before attempting any maintenance or cleaning. Turning off the PSX-240 may not reduce
this risk.
4.
No terminals or lugs are required for hook-up of the AC wiring. AC wiring must be copper wire and rated for
75
°
C or higher.
ADDITIONAL NOTICES
1.
For instructions on mounting, see the Mechanical Installation section of this manual.
2.
All installations must comply with local and national electrical codes and standards.
3.
All installations must comply with local and national codes for structural installation.
