Out of the Box uPad, Инструкция по сборке

Страница: 7 / 10

Electronics and Robotics LLC
ootbrobotics.com
1. Break one of your 40 pin headers into 10x 4 pin headers
2. Break two of your 40 pin headers into 5x 8 pin headers each
3. Break one of your 40 pin headers into 3x 6 pin headers and 2x 11 pin headers .
4. Break one of your 40 pin headers into 6x 5 pin headers and 1x 10 pin header .
Step 1: PORTB/ANALOG Headers
Figure 4: Location of PORTB/ANALOG Headers
Flux the hole closest to the label AFE7 on the top of the board, and insert a 4 pin
header from the bottom of the board.
Figure 5: Top of Proto Base with header in PORTB/ANALOG section
Load up your soldering iron with solder, and apply it to the AFE7 pin you fluxed
previously. This will tack the 4 pin header to the board just like Figure 5 above.