Our K9 Royal Blue, Руководство пользователя, Страница: 4 / 8

Putting the Collar on Your Dog:
Remove the battery so the collar has been disabled. And put the collar together and adjust to
the correct length, And screw on the correct size prongs, these prongs MUST be against your
dog’s skin to work, Short prongs for short haired dogs, long prongs for long haired dogs…
To Put your collar together correctly please watch this video, When the collar has been
assembled correctly the collar DOES NOT SLIP, IT WILL NOT LOOSEN.. If you are
experiencing problems with the collar loosening please re-watch the video using the pause
button. Click this link to correctly assemble your collar…
https://www.youtube.com/watch?v=3DdbMexrnwY
If the Collar is too long then cut the excess and trim the end, then seal using a flame, watch
this video to do it correctly….
https://www.youtube.com/watch?v=7SEBi8Sfgkw
Place the collar around your dog’s neck, it must not move, if it does then adjust and tighten the
collar. Hold the unit and try to move it, when it does not move and you can slide just one finger
under the collar that is now correctly fitted.
Now leave the collar on your dog, Do Not put the battery back in…. Wait for 24 – 48 hours until
your dog totally ignores the collar, initially they will scratch at it and just paw at it, when that
completely stops we are ready to start the training.
You must be present when you put the battery into the collar and start the
training...
To put the battery into the collar correctly watch this video:
https://www.youtube.com/watch?v=jrokbOQemj0
Now you have the battery in the collar let’s test it to make sure everything is OK .
Watch this video to learn how to test your collar correctly…
DO NOT UNDER ANY CIRCUMSTANCES PUT THE COLLAR ON YOUR DOG
WITHOUT FIRST TESTING IT….
Testing the Collar, No you do not have to bark at it… Just hold it up with the back of the collar
facing you, there is a small hole between the two prongs, just puff into the hole and the collar
will beep, do it again, and the collar will beep again. Now do it a third time and the collar will
beep and then vibrate. Now you know you collar is working correctly. We have this video
which shows you exactly how to do it… please refer to Fig 1 On what your collar should do.
https://www.youtube.com/watch?v=uK3XAJlB6JI
Now You have tested the collar take the sensitivity all the way down to number 1
by pressing the – button on the collar… If your dog barks and the collar does not
beep, press the + button once this will increase the sensitivity to number 2, if your
dog barks again and no beep, once again press the + button, continue this until
the collar beeps immediately after your dogs bark. NOW YOUR COLLAR IS SET
UP CORRECTLY….