6
SIM card slot
SIM card push-button
Antenna
attachment
Modem
Atachment
plate
Plate spring
which is taut
A modem which is attached to the wall,
viewed from the back
Attachment hook
for DIN-rail
Modem with
pr
ea
tta
ched
pla
te
DIN-rai
Products:
EH-60 and EH-686
A
B
C
D
EH-200/
EH-105/
Lämpöässä/
Geopro
yellow
brown
green
jumper wire
Connector cable
C
A
EH-60/
EH-686
green
yellow
brown
Connector cable
Power supply
230V/12VDC
Power (8–32VDC) is supplied to the modem using either the mains adapter or the battery cable
Products:
EH-200, EH-105,
Lämpöässä and
Geopro
If EH-60 or EH-686 has a battery
backup, connect the operating vol-
tage directly to the battery char-
ger-power source, AP1. (A power
supply is not needed).
Power supply cable to
8...32V operating voltage
Installation
Press the small black push-button at the end of the modem
and pull the SIM card slot out of the modem at the same
time. Place the SIM card in the slot and push it back into
place.
To be able to use the SMS-connection, the PIN code has to
be installed in the controller. Note. The controller is given the
same PIN as that of the SIM card.
The SIM card’s PIN query
must be on.
Installing SIM card
The
EH-60/EH-686
should
be powered off after the
modem is connected so that
the device will recognize the
modem.
Connecting the GSM modem to Ouman regulation and control devices
Use a DIN rail to fasten the modem into place. Attach
the DIN rail to the wall.The modem has a preattached
plate that can be attached to the DIN rail.
Place the upper edge of the plate above the upper
edge of the DIN rail.
Lower the modem so that the spring on the base be-
comes taut against the DIN rail and the hooks on the
upper edge of the plate go into place on the DIN rail.
Press the lower edge of the modem against the rail so
that the hooks on the lower edge of the plate become
attached to the rail.
12 VDC
Bla
Red
