11 / 12
1. Press the up/down button to adjust the height of the desk; double click the up/down button to automatically adjust the height of the desk. Press
the up/down button once again to stop moving the height of the desk. When the desktop runs to the lowest position, the screen will display “bot”.
Otherwise, the desktop will display “top” when the desktop runs to the highest position.
2. Key button: “1”,“2”,“3”,“4” are the four height memory keys, long press the button about 5s to record the current height.
3. Press the “3” and the “4” buttons together at the same time for 5s, “RST” will be displayed on the screen, keep pressing “▼” button until
the desk reaches the lowest position and then bounce up to stop, meaning the desk can work normally.
4. The desk has one Type-A port and one type-C port. Each port can power other digital devices, supporting charging protocol:
One USB port: 5V 3A/9V 2A/12V 1.5A/20V 1.35A 27W Max,
One Type-C port: 5V 3A/9V 3A/12V 3A/15V 3A/20V 2.25A, 45W Max,
Dual ports: 7.5W+7.5W. Output will be cut when the desk is rising or going down and when the movement stops, the port will start to output.
5. Long press the “up” and “down” button 5s together at the same time to adjust the sensitivity of anti-collision function with a buzzer sound. The
anti-collision function will be closed when the screen shows “A-0”; the sensitivity is at low sensitivity when the screen shows “A-1”, the sensitivity
is at medium sensitivity when the screen shows “A-2”, the sensitivity is at high sensitivity when the screen shows “A-3”, the level 3 has the maximum
sensitivity.
The following tips will help you detected and eliminate the common fault and
error. If the fault you met is not listed below, please contact 1300 OFFICE
(
1300 633 423
).
Only the manufacturer and professionals are capable for
investigating and correcting those fault and error.
a. Reset: When the LED shows" ", press " " button until the desk reaches its lowest height and rebounds to stop, it means the reset
has been finished.
b. When "step a" doesn’t work and the LED shows " E01 " or " E02 ", please retry 18 minutes later.
c. If the " " button doesn’t work, please check the cable connection and then cut off the power for at least 10 seconds. Reconnect to the
power and press " " button to start the reset process when it shows hte " ".
d. If all these above process are inefficient, please contact our customer service.
Troubleshooting:
Error Code
Description
Method
E01
E02
E03/E04
E05/E06/E10
E09
Overwork
Overtemperature
Overloaded
The legs cannot move in the process of
rising or going down
The weight distribution on two sides of table
is severely unbalanced.
All the cables be connected well
Please retry 18 mins later
Please retry 18 mins later
Please reset
Please reset
Please reset
Please reset
E07/E08/E20/E21/E22//E23
