Otto Bock Start B2, Инструкция по эксплуатации

Страница: 15 / 44

7 8
Version 2
1) Slightly loosen the hexagon nut on the inside of the frame (see fig. 9; see fig. 10, item 1).
2) The knee lever wheel lock is continuously moveable/adjustable (see fig. 10, item 2).
When the wheel lock is disengaged, the gap between the tyre and wheel lock bolt must not exceed 5 mm .
Ensure that the wheel lock bolt covers at least half the tyre width during braking.
3) Tighten the hexagon nut to
7 Nm
.
→
After adjustment, the left and right knee lever wheel locks must both have the same braking force.
9 10
7.5 Installing the wheel lock lever extension
1) Pull the wheel lock handle off the knee lever wheel lock. Cut open if necessary.
2) Slide the wheel lock lever extension onto the wheel lock lever and secure it with the pin (see fig. 11, item 1).
3) Check the folding function.
11
15 Start B2
Settings and assembly instructions