Otto Bock SKIPPI, Инструкция по эксплуатации

Страница: 16 / 68

WARNING
Exposed pinch points
Pinching, crushing of limbs (e.g. fingers) due to lack of caution in danger areas
► While adjusting power seat options, note that inherent pinch and shear points are located between the seat
frame and the power wheelchair frame.
►
Ensure that no body parts, such as hands or feet, are in the danger zone while you make adjustments to
power seat options.
CAUTION
Unsecured screw connections
Pinching, crushing, tipping over, falling of user due to assembly errors
►
After all adjusting/readjusting work, retighten the mounting screws/nuts firmly. Observe any torque settings
which may be specified.
► Any time you loosen a screw connection with thread lock, replace it with a new screw connection with thread
lock or secure the old screw connection with medium strength thread locker (e.g. Loctite®241).
CAUTION
Improper lifting
Crushing, pinching, blows due to failure to observe safety instructions
► Some parts of the power wheelchair, such as the batteries, frame, seat, and motors, are very heavy. Ensure
ergonomically correct lifting of these parts. Use sufficiently large hoisting devices or perform this work with a
helper.
►
If it is necessary to work underneath raised parts or equipment, make sure these are secured by suitable
means so that they cannot come loose, shift, or fall down.
► When using lifting platforms, ensure that the power wheelchair is centred on the platform and that no parts
protrude into the danger zone.
NOTICE
Improper preparation before making adjustments
Damage to the product due to falling down and failure to follow setting instructions
► When you work on the product, secure it so that it cannot tip over or fall over.
► Turn the power wheelchair off and remove the fuse before making any adjustments. Functional tests of the
electrical components are excepted from this rule.
► Before performing any work on the seat, ensure that the cushion is sufficiently protected against mechanical,
chemical, and thermal effects.
NOTICE
Use of unsuitable packaging
Damage to the product caused by transportation using incorrect packaging
►
Use only the original packaging for delivery of the product.
7.2.2 Adjusting the standard seat
7.2.2.1 Adjusting the seat angle
CAUTION
Improper adjustments
Falling of the user out of the seat due to user error
►
The user must not sit in the wheelchair during seat angle adjustments.
If necessary, the seat angle can be adjusted in 3 increments (-6°, +3° and +12°).
16
Settings
Skippi