Otto Bock Motus CS, Инструкция по эксплуатации, Страница: 13 / 36

11
6.2.5 Adjusting the quick-release axle
The quick-release axle should be set so the wheel is correctly engaged, with no play on the axle.
1) Hold the quick-release axle by the head (wrench size:
19 mm
) and by the tip (wrench size:
11 mm
) with a ring
and open-ended wrench respectively.
2) Adjust the play by turning the nut on the end of the quick-release axle (see fig. 12, item 1) in or out.
12
6.2.6 Adjusting the handrims
INFORMATION
This section does not apply to standard wheels.
All handrims are designed for a spacing from the drive wheel of
15 mm
(standard setting) and
25 mm
(see fig. 13).
1) Loosen/remove the handrim screw connections from the rim.
2) Tightly screw the handrims onto the rim in narrow or wide installation position (see fig. 14).
13 14
13 Motus CV, Motus CS
Settings