Otto Bock Dino 3, Инструкция по эксплуатации

Страница: 9 / 32

INFORMATION
Please also observe the adjustment instructions in the section "Settings" (see Page 11 ff.).
6.1 Installing the Ottobock Shape seating solution (option)
This option may only be installed by Ottobock at this time.
6.2 Installing interface adapters for other seating solutions (option)
The following interface adapters can be installed:
•
Trapezoid adapter
• Parallel adapter
The removal and attachment of seating shells/seating solutions on the interface adapters is described in more
detail in the enclosed instructions for use (user).
Removing/installing the interface adapter:
1) Remove the seating shell/seating solution with the seating shell interface.
2) Loosen and remove the screw connections on the interface adapter and seat bars on both sides (see fig. 1,
item 1).
3) Remove/replace the interface adapter (see fig. 1, item 2).
4) Insert the screw connections into the appropriate slots on the interface adapter and seat bars and tighten them
to
6 Nm
(see fig. 1, item 1).
5) Reattach the seating shell/seating solution with the seating shell interface.
1
6.3 Installing other seating solutions
In principle, it is possible to install seating solutions from other manufacturers on the product. In this case, liability
rests with the qualified personnel that completed the installation.
Installation by Ottobock Custom Fabrication is possible with a separate order.
The manufacturer assumes no liability for combinations with seating solutions that have not been approved by the
manufacturer.
6.4 Installing the back support guide for seating shells (option)
The back guide for seating shells is attached to the cross tube of the back frame. The guide plate is attached to the
back of the seating shell using 4 screws (see fig. 2, item 1) and connected to the back guide:
1) Loosen the clamping screw on the back guide (see fig. 2, item 2).
2) Insert the clamping plate into the guide plate, narrow side first (see fig. 2, item 3).
3) Turn the clamping plate
90°
so that it engages sideways in the guide plate. (see fig. 2, item 3).
4) Firmly tighten the clamping screw on the back guide (see fig. 2, item 2).
9 Dino 3
Installing options/accessories